Where are the low beams on a Chevy Silverado?

How to replace low beam headlight-2011 Sierra?

Twist the bulb and pull it out. It’s self explanatory once you see it. The passenger side you need to remove the airbox. The passenger side was very easy take the top of the air box off then reach around and twist off the light . but the driver side you have to tear half the truck apart At least I did when I had my 2012 Silveraldo

Why are my headlamp low beams not working?

The BCM energizes the HDLP LO/HID relay located in the under hood fuse box , sending B+ voltage to fuse’s # 12 & 16 both 20 amp . LO HDLP – LT & LO HDLP – RT , These are B+ voltage for low beams . Your headlamp low beam relay could be bad or if the BCM isn’t energizing it could be a switch problem .

How to Change headlight bulb on 2011 Silverado?

Make it. Fix it. Figure it out. An error occurred while retrieving sharing information. Please try again later.

Why does my driver side low beam light not work?

So driver side low beam doesn’t work I replaced the bulb and still nothing, high beam fog light and parking lights work fine, also passenger side turn signal lights are on but do not blink when activated and I get a display saying right front turn indicator failure, I tried replacing those bulbs and still no change any ideas? Thanks in advance

Make it. Fix it. Figure it out. An error occurred while retrieving sharing information. Please try again later.

Why do high beam headlights work but low beams don’t?

Most headlight systems are also designed with a relay that switches the power between low beam and high beam headlights. If this relay goes bad, it could allow power to the high beams, but not the low beams. 1. Headlight Bulbs This is the most common reason we see for why a car’s high beam headlights work but the low beams don’t.

Where are the fuses on the passenger side low beam?

That is for the passenger side low beam. Picture 1 is the fuse box under hood specific to your vehicle. Look at the picture, locate number 16 and then locate it in the truck. Once you locate it, then you can check it. Pictures 2, 3, and 4 are the legend for what each fuse does. You will see that each light and beam choice has its own fuse,

Where is the low beam bulb on a headlight?

With the lower half of the air box removed, you can easily access the low beam bulb at the top and the high beam bulb just below it. Rotate the base of the low beam bulb 1/4 turn counter clockwise and pull it straight out of the headlight housing.

What should the low and high beams be aimed at?

Low beams should be aimed straight forward and hit no higher than your hood line. The high beams should move slightly, but not too much higher than the low beams. If they need to be adjusted, there are screws on the back or top of the housing to allow you to do so.

Where is the high beam bulb on a Chevy Silverado?

Insert the new low beam bulb in to the headlight assembly and rotate it 1/4 turn clockwise to lock it in place. The high beam bulb is located at the bottom of the headlight assembly. Unlike the low beam, the high beam bulb’s installed or “locked” position is at an angle.

Why is the low beam light out on my Dodge Ram?

I swapped the known good bulb from the other side and the low beam was still out, even though the high beam and fog lights were all functional. I started researching other causes for the issue and discovered that 2006 and later model year Dodge trucks have no fuses nor relays controlling power to the lights.

Where are the low beams on a Chevy Silverado?