What to do if fuel injector is not triggered?
What to do if fuel injector is not triggered?
If the injector is not being triggered you will not have fuel getting into the engine’s cylinders. Disconnect the electrical connector at the fuel injector with the ignition key in the “on” position, (next position after the accessory position) you should have 12 volts at one of the two wires at the injector.
Why does my car engine not want to start?
If the engine still doesn’t seem like it wants to start, probably fuel is getting into the cylinders and your problems lies somewhere else. However, if the engine runs momentarily and dies, then the problem is that fuel is not getting to the cylinders. Check for a clogged fuel filter, or a bad fuel pressure regulator.
How does the fuel injector work in a car?
When the engine is running the second wire at the injector gets (triggered) grounded by the computer in your vehicle many times a second controlling exactly when and how much fuel gets injected into the engine. Check for ignition spark.
What kind of spark tester do I need to start my engine?
You can do this test without a spark tester, but it’s better to use one because a weak spark as well as a missing spark can prevent your engine from starting. If possible, use an adjustable tester so that you can test for 40KV, 30KV, and 10KV spark.
What does it mean when there is no injector pulse?
In case of that, there is no injector pulse or spark, this means that is your ECU has failed in operating in this case you have to get your ECU changed or visit an expert. You May Like: Low Fuel Light Comes on When Tank Is Full Causes and How to solve it Question: What controls the fuel injector pulse?
Why does my carb spray have no injector pulse?
I have no injector pulse. I have plenty of fuel pressure and both crank sensors and the cam sensor are good. If I spray carb spray through a vacuum hose, it runs fine, but I’m getting nothing through the injectors. What else besides the PCM would control the injectors other than the cam and crank sensors?
What happens if there is no injection signal?
The ECU cannot pulse the injector without an Ne signal and will not start or run if this signal is not present. If the G signal is not present while cranking the engine, the ECU will not be able to identify when to produce the injection signal. The result will be the same, no injection pulse.
What causes no power to fuel injectors?
The most important signals that determine the accuracy of a signal coming out of ECU to injectors are crankshaft position sensor and camshaft position sensor, so to test a bad injector, you have to check the voltage on the injector when the ignition key is turned on: NO VOLTAGE? , so what causes no power to fuel injectors?
