What kind of oil goes in a blower?

If you choose a conventional oil, ambient temperature is taken into consideration. Since the ambient temp is usually above 32 degress F, then an ISO 220 to ISO 320 viscosity (SAE 50 or SAE 90 Gear Oil) should be used.

How much boost can a 8-71 blower make?

Weiand Pro-Street 6-71 and 8-71 supercharger kits come with drive ratios that will typically produce 5 to 7 pounds of boost. These boost levels are based on 350 or 454 cid engines.

How much does a 871 blower weigh?

Blower weights 80 lbs.

How much power can a 671 blower make?

Driven 11 percent under, the 6-71 produced a boost curve that began at 4.2 psi at 3,300 rpm and rose to 8.3 psi at 6,400 rpm. This pulley combination produced peak power numbers of 602 hp at 6,400 rpm and 551 lb-ft of torque at 4,700 rpm.

Is a blower the same as a supercharger?

The difference between a supercharger and a blower is that a supercharger is mounted to the front of a vehicle and piped to the intake, whereas a blower is mounted to the intake on the block. Another difference is that a supercharger is belt-driven and forces only air into the manifold.

How much does a 6-71 supercharger weigh?

6-71 and 8-71 usually take approx. 16 oz 10-71 14-71 sometimes take about 20 oz. Q. How tight should I run my blower belt?

How to calculate the CFM of a blower?

Basic Blower Measurements To Figure Out The Cubic Feet Per Minute Of Each Revolution Of The Blower: CFM of Blower: Regular twist blowers:Cu in/rev = rotor length X 27.45 High-helix blowers:Cu in/rev = rotor length X 31.53 Basic Blower Measurements

What kind of bearings does a street blower use?

The blower uses double lipped Teflon seals to provide superior seal on the rotor shafts with hi-speed double row ball bearings and helical steel gears to keep the rotors in time. Billet alum. rear bearing plate, front bearing plate, and billet front gear cover offer maximum strength and gives a superior polish.

What kind of oil do you use in your blower?

Use the same in my General Pump, change them both at the same time. Aeon PD is the best choice for Sutorbilt (Gardner Denver), but actually using the Aeon PD on other blower makes, may invalidate your warranty. This is because the manufacturers specify slightly different straight viscosity grades if you choose a synthetic.

What should the deflection be on a blower belt?

A. The blower belt adjustment should be done with the motor cold, and have 3/4″ deflection in or out on the long side of the belt. This should give you 1 1/2″ total deflection. Once the motor is warm this will decrease to roughly 1/4″ deflection in or out, or a total deflection of 1/2″.

Is the bl-871 Stage 3 polished blower back order?

BL-8713-0000 NEW 871 STAGE 3 POLISHED BLOWER, BILLET HA ROTORS (This item will soon be discontinued) Back Order. In Stock.

What kind of oil goes in a blower?