What causes a Chevy S10 to start sputtering?

Normally it idles around 950-1050 RPM, what has been happening is that it would start, idle high, around 1500, then drop to normal, and then start sputtering and RPMs would fluctuate anywhere between 750 on the high side, all the way to 0, stalling the motor.

Why does my truck sputter and backfire when I accelerate?

Hey I’m new here and desperate for answers! I’m in the middle of PCSing with the Air Force to Japan and was getting my truck ready to sell, when it started acting up when I accelerated after right after starting the engine. een The engine starts and runs fine, when I leave for or from work.

What causes a car engine to make a sputtering noise?

The car has a set of vacuum hoses that, with time, develop leaks. This will cause the engine to produce a sputtering sound when the air-fuel mixture gets too rich or too lean. 4. Dirty mass airflow sensor The combustion chamber requires the right amount of fuel and air.

Are there any issues with the Chevy S10?

After that it started having a number of other issues, such as power loss, really bad acceleration, stalling, and a really rough idle.

Can a bad fuel filter cause a Chevy S10 to stall?

One of the worst problems that can happen to your Chevy S10 is a bad fuel filter. When the filter goes bad, it can limit the amount of fuel that enters the engine. Without fuel, the vehicle will not run at all. With that in mind, most of the symptoms of a bad fuel filter revolve around the vehicle stalling out.

What kind of engine is in a 1991 Chevy S10?

It’s a 1991 Chevy S10, 2WD P/U, 2.5L I4 engine with around 185,000 miles on it. It’s the Iron Duke engine, a throttle body injection motor. I’m not a mechanic, please forgive me if I use the wrong terminology.

What kind of noise does a Chevy 4.3 make?

by Contributor. A common complaint with the Chevy 4.3 engine is that it doesn’t idle well, it’s loud and makes awkward noises. Examples of this are staling, lurching and poor acceleration. Poor idling and loud engines usually go hand-in-hand.

What causes hesitation and stumbling in a 1990 Chevy c1500?

An expert that got 10 achievements. Re: 1990 chevy c1500 hesitation and stumbling during… Based on what you said, I would say the engine is starving for fuel. The computer has to be disabled to set timing – there should be a procedure for that. I would start with checking fuel pressure at the throttle body.

How do you change the idle speed on a T-30?

Insert a T-30 size Torx driver into the Idle adjustment screw that is located behind the plug removed earlier. Turn the screw to adjust the idle speed to 650 RPM +/- 50 RPM. Turn off the engine and disconnect the negative battery terminal from the battery using a wrench. Reconnect the IAC valve.

What’s the problem with my Chevy S10 Blazer?

My 92 S10 blazer w/ FI, V6, std. trans., runs for about 5 minutes then dies and will not start. If left to sit the process will repeat. Let it sit overnight and it starts. I have tried letting it sit for an hour and it didn’t.

What causes a car engine to start spluttering?

Causes for engine splutter 1. Faulty spark plugs 2. Dirty fuel injectors 3. Vacuum leak 4. Dirty mass airflow sensor 5. Exhaust system leaks 6. Faulty catalytic converter 7. Dirty oxygen sensors 8. Worn out seals/gaskets

What’s the problem with my Chevy S10 4.3?

I have this same problem with my 99 s10 4.3. the code reader says miss fire cylinder #2… so I replaced wires, plugs, distributer cap and rotor. after 2 days this problem got worse. again I read the codes and it read the same code, cylinder #2. good old GM I guess 71 people found this helpful.

Why did my Chevy S-10 misfire in the morning?

My morning misfire was caused by a bad intake manifold gasket (a very common problem with most gm models around 2000 model year. Caused by crappy dexcool coolant ). After sitting overnight a small amount of coolant would get into right rear cylinder. It would miss for a bit and then run fine. Doesn’t have to be leaking a lot either.

Why does my C / K C10 stop running?

I have a 1984 c10 with a 85-86 Trans am 305 motor that was running ok this morning, well tell me why when I go try to turn it back on few hours later starter starts making grinding noise and is unable to turn the engine just my luck so I go to the auto parts store pick up a new starter slap it in and go to turn the ignition and NOTHING happens …

Why does my Chevy S10 stall at idle?

Pulling over and letting it sit for 10 15 minutes sometimes fixes the issue long enough for me to get home. Sometimes the problem happens again after 5-10 more minutes of driving. Truck otherwise runs great at idle, is not hard to start, doesn’t seem to use excessive fuel.

What are the symptoms of a bad distributor rotor and cap?

Symptoms of a Bad or Failing Distributor Rotor and Cap Common signs include engine misfires, car not starting, the Check Engine Light coming on, and excessive or unusual engine noises. by Valerie Johnston on January 07, 2016 Vehicle Engine Mechanical Inspection Cost

Is there a leak in my Chevy S10?

The leak is showing up on the top front left part of my 4.3 Vortec Z engine.Like right next to the Thermostat housing.Is it possible the Lower intake Manifold could be leaking. the engine runs fine other than the leak. We have a 2000 S-10 with the same engine.

What’s the fuel pressure on a Chevy’s 10?

I checked the fuel pressure and it is reading 11psi down to about 7psi. The pressure moves down and back up slowly as you race the engine and basically is pretty stable most of the time around 9-10psi.

Why does a dirty fuel filter slow down a car?

Dirty fuel injectors The fuel injectors play the role of spraying fuel into the combustion chambers. This is then mixed with air and ignited by the spark plugs. When the fuel filter is dirty, then you have less fuel going to the combustion chambers. This will cause your car to experience slow acceleration.

What are the symptoms of a bad idle control valve?

$0.00 1 Irregular idle speed One of the most common symptoms commonly associated with a problematic idle air control valve is irregular idle speed. 2 Check Engine Light comes on Another symptom of a potential issue with the idle control valve is an illuminated Check Engine Light. 3 Engine stalling

Why does my car run rough at idle?

That is to say combustion may be disrupted. You will feel, and maybe hear, this as a brief stutter in the engine. You might feel that the engine runs rough or vibrates at idle, say, when you’re sitting at a red light. This is similar to the above in that it stems from poor spark timing.

Why do I hear a stutter in my engine?

That means the engine will need to use more gas and your morning commute will use up more fuel than usual. Lack of proper spark timing can cause a different problem: one or more of the cylinders may misfire. That is to say combustion may be disrupted. You will feel, and maybe hear, this as a brief stutter in the engine.

What causes the Check Engine light to come on?

A failing or failed crankshaft position sensor may cause the check engine light on your dashboard to come on. A diagnostic scan tool will show a code between P0335 and P0338. The check engine light doesn’t always come on, though, so you could be experiencing any of the above symptoms for some time before you see the warning light.

What causes a Chevy S10 to start sputtering?